HANGCHA Mini CBD15-A3MC1 - Page 78

83
FLASH CODE
NAME
CAN INDEX
POSSIBLE CAUSES
FAULT
TYPE
SET CONDITION CLEAR CONDITION FAULT ACTIONS
6
The Pot Hi Switch Function
parameter specifies a
value other than Pot Hi
Input but the Throttle Type
parameter specifies a
3-wire pot throttle.
Cycle the keyswitch.
7
The Inching Input Source
parameter specifies
Inching Switch but the
inching function is not
assigned to a flexible
switch input.
Cycle the keyswitch.
83
NV Failure
0x2830
FRAM operation failed
Block
num-
ber
Read FRAM failed. Cycle the keyswitch.
Shut down motor
Shut down main
contactor
Shut do wn EM brake
Shut do wn throttle
Shut do wn interlock
Shut do wn DRIVERS
2 Write FRAM failed.
3
Restore parameters failed
during flashing.
4
Saving the brownout
flag failed.
5
Block number is out
of range.
84
Supervision
0x2840
Cross check failed.
See
Table
7-2
Cross check failed Cycle the keyswitch.
Shut down motor
Shut down main
contactor
Shut do wn EM brake
Shut do wn throttle
Shut do wn interlock
Shut do wn DRIVERS
The following table lists the fault types for the Supervision fault.
Table 7-2 Supervisor Fault Types
Fault Type Fault Type Variable
2 SUPERVISOR_FIFTEEN_V_SUPPLY_FAILURE