Setup/Installation 11
The following General Setup options are displayed regardless of the sensor
being used. These settings remain when switching to another probe type or
when no probe is attached. Options are tabulated in the table below with choices
and default values. Options are accessed by pressing SETUP. Loop through the
options by using the pq arrows. To modify a setting, press MODIFY. The option
may be modi ed by using u, p and q keys. Press CFM to con rm the change. To
exit SETUP press SETUP.
Option Description Choices Default Basic mode
*Only seen
when cable
connection
between micro
USB and PC is
made.
Select if PC is
being used for
charging battery
(and meter
will be used
for logging) or
if Data will be
exported to
the PC.
LOG ON EDGE or
EXPORT TO PC
LOG ON EDGE Available
Log
Select log type
to be used
from 3 types of
logging:
Manual log on
demand
Manual log
on stability
(3 types of
stability criteria
available)
Timed interval
lot logging
Manual Log
Stability Log:
Fast, Medium,
Accurate;
Interval Log:
Seconds: 5, 10,
30; Interval Log
Minutes: 1, 2, 5,
15, 30, 60, 120,
180.
Interval
(5 Sec)
Manual log
or
Stability log:
Medium
Set Calibration
Expiration
Warning
Meter will
indicate “CAL
DUE” when
set time in this
parameter has
been exceeded.
1, 2, 3, 4, 5, 6, 7
days or OFF
7 days Not available
Probe Speci c
Parameters that are speci c to a measurement type are inserted here in
the SETUP list.
Set Date
Press MODIFY
key to Set current
date, displayed
in ISO format.
Press CFM to save
changes.
YYYY/MM/DD
Date
Set date Available
Set Time
Press MODIFY
key to Set current
time, displayed
in ISO format.
Press CFM to save
changes.
24hr:MM:SS
Time
Set time Available
General
Setup
To Next Page
Loading...
Need help?
General
