Need help?Do you have a question about the Hanna Instruments HI93703-11 and is the answer not in the manual?
General| Model | HI93703-11 |
|---|---|
| Light Detector | Silicon Photocell |
| Operating Temperature | 0 to 50°C (32 to 122°F) |
| Measurement Range (Chlorides) | 0.0 to 20.0 mg/L (ppm) |
| Resolution (Chlorides) | 0.1 mg/L |
| Method (Chlorides) | Mercuric Thiocyanate |
| Relative Humidity | up to 95% RH non-condensing |
Identifies key instrument components including the measurement cell, LCD, and RS232 port.
Details the functions of the ON/OFF/CLR, GLP/CAL, STO/VIEW, READ/DATE, and ALT keys for operation.
Step-by-step guide detailing the process of performing turbidity measurements using the meter.
Instructions for saving sample readings to memory for subsequent review and analysis.
Procedures for erasing stored sample data and accessing logged measurements from the meter's memory.
Procedures for viewing and modifying the meter's internal date and time settings.
Explains common error codes displayed by the meter and provides guidance on their resolution.
Identifies factors affecting measurement accuracy, such as debris, air bubbles, and sample color.
Detailed steps for calibrating the turbidity meter using standard solutions for accurate readings.
Instructions on how to check the date and time of the most recent calibration performed.
Instructions to display the installed firmware version of the turbidity meter.
Best practices for sample preparation and glassware cleaning to ensure accurate calibration results.
Explains the two primary calibration standards: AMCO-AEPA-1 and formazine.
Guidelines for the proper disposal of the instrument as per electrical and electronic equipment recycling standards.
Instructions for the responsible disposal of batteries, preventing contamination of household waste.
Advice on application suitability, performance, and safe storage practices in hazardous environments.
To Next Page