10
OPERATIONAL GUIDE
6. OPERATIONAL GUIDE
To prepare the instrument for taking measurements, first install
the batteries (see Battery Replacement section) and then turn the
instrument on.
To maximize battery-life, the display is automatically switched off
after 5-minutes of non-use. To reactivate the display, simply press
the ON/OFF key.
6.1. MEASUREMENT PROCEDURE
• Turn the meter on by pressing the ON/OFF key.
• The meter will carry out a self-test displaying a full set of figures.
• The meter will carry out a battery test showing in percentage the
battery life left.
• When the LCD displays “----” the meter is ready to measure.
• Fill a clean cuvette up to one quarter inch (0.5cm) from its rim
with the thoroughly agitated sample.
To Next Page
Loading...
