15
OPERATIONAL GUIDE
• Press right arrow to scroll to month and day, use UP/DOWN to set.
• Press right arrow again to scroll to time, use UP/DOWN to set.
• Press right arrow again to save and exit date and time setup.
Note: Press ALT & DATE to leave this mode without saving.
6.6. ERROR CODES
Every time the meter is switched on, the Real Time Clock and EEPROM
are tested, and if an error is found the corresponding error code will
be displayed.
The list of error codes is as follows:
• NO cover error (check cuvette position)
• Calibration error (check calibration standard value)
• Real Time Clock error*
• EEPROM error*
To Next Page
Loading...
Need help?
General
