Operating Data Logger
USER’S MANUAL 23
: Start to acquire data.
: Get users’ help.
: Set data interval 1s, 2s, 5s, 10s.
2. Making an AC Voltage Measurement
To measure the AC voltage, follow these steps:
1) Click the “V” key and DC appears on the screen.
2) Click “DC” key and AC appears on the screen.
3) Connect the black lead into the COM banana jack input and the red lead into the V/Ω/C banana
jack input.
4) Connect the red and black leads to the measured points and the AC voltage value of measured
points will be displayed on the screen.
Connect Data Logger probes(HT325) with Hantek365 as illustrated in the following figure:
Figure 2-3
Then, the following figure will be displayed:
Figure 2-4 AC Voltage Measurement
To Next Page
Loading...