Operating Data Logger
USER’S MANUAL 22
2.1 Making Voltage Measurement
1. Making a DC Voltage Measurement
To measure a DC voltage, follow these steps:
1. Click the “V” key and DC appears at the top of the screen.
2. Connect the black lead into the COM banana jack input and the red lead into the V/Ω/C banana
jack input.
3. Connect the red and black leads to the measured points and the voltage value of measured
points is displayed on the screen.
Connect Data Logger probes(HT325) with Hantek365 as illustrated in the following figure:
Figure 2-1
Then, the following figure will be displayed:
Figure 2-2 DC Voltage Measurement
: Save data as .txt.
: Clear the right data list.
To Next Page
Loading...