Need help?Do you have a question about the Hantek CC-65 and is the answer not in the manual?
General| Brand | Hantek |
|---|---|
| Model | CC-65 |
| Category | Test Equipment |
| Language | English |
Connect the clamp to a multimeter or scope and set the power switch to ON.
Zero the clamp using adjustment knobs before measuring DC current.
Clamp jaws around conductor and interpret readings based on selected range.
Measure conductors with voltage less than 300V DC or 240V rms AC.
Do not measure conductors with damaged or worn insulation.
Max conductor size 9mm; low battery indicator is red LED.
Operating: 0-50°C, 70% RH. Storage: -20-70°C, 80% RH.
9V battery, 100hr life, 250g weight, specific dimensions, wire output.
Details ranges for 1mV/10mA, 1mV/100mA, and higher currents.
Defines clamp precision and system accuracy with multimeter/scope.
Accuracy specifications for DC current measurements.
Accuracy specifications for AC current measurements across frequencies.
Specifies load resistance and temperature coefficient for accuracy.
Complies with EN 61010-1, EN 61010-2-032, IEC 664 standards.
Complies with EMC and Low Voltage Directives (CE marking).
To Next Page
