Need help?Do you have a question about the Hantek 6022BE and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Bandwidth | 20 MHz |
| Sample Rate | 48 MSa/s |
| Resolution | 8 bits |
| Interface | USB 2.0 |
| Input Sensitivity | 20 mV/div to 5 V/div |
| Power Source | USB Powered |
| Input Impedance | 1 MΩ |
| Coupling | AC, DC, GND |
| Trigger Modes | Edge, Pulse |
| Trigger Sources | CH1, CH2 |
| Operating System | Windows |
| Dimensions | 35 mm |
Specifies the minimum and recommended computer configuration for the oscilloscope software.
Guides users through the process of installing the oscilloscope software from the CD-ROM.
Details the steps for connecting the oscilloscope and installing its USB driver on the PC.
Explains how to perform a functional check to ensure the oscilloscope operates correctly.
Describes the procedure for matching probe characteristics to the oscilloscope's channel input.
Outlines the routine for optimizing the oscilloscope's signal path for accurate measurements.
Explains the graphical user interface of the oscilloscope software.
Explains how to use cursors and the measurement menu to analyze waveform parameters.
To Next Page
