Hantek 6022BE
General Safety Summary
Review the following safety precautions carefully before operate the device to
avoid any personal injuries or damages to the device and any products
connected to it.
To avoid potential hazards use the device as specified by this user’s guide
only.
To Avoid Fire or Personal Injury
Use Proper Power Cord. Use only the power cord specified for this
product and certified for the country of use.
Connect and Disconnect Properly. Do not connect or disconnect
probes or test leads while they are connected to a voltage source.
Connect and Disconnect Properly. Connect the probe output to the
measurement device before connecting the probe to the circuit under test.
Disconnect the probe input and the probe reference lead from the circuit
under test before disconnecting the probe from the measurement device.
Observe All Terminal Ratings. To avoid fire or shock hazard, observe all
ratings and markings on the product. Consult the product manual for
further ratings information before making connections to the product.
Use Proper Probe. To avoid shock hazard, use a properly rated probe for
your measurement.
Avoid Circuit or Wire Exposure. Do not touch exposed connections and
components when power is on.
Do Not Operate With Suspected Failures. If suspected damage occurs
with the device, have it inspected by qualified service personnel before
further operations.
Provide Proper Ventilation. Refer to the installation instructions for
proper ventilation of the device.
Do not operate in Wet/Damp Conditions.
Do not operate in an Explosive Atmosphere.
Keep Product Surfaces Clean and Dry.
1
The User’s Manual
To Next Page
Loading...
