Hantek 6022BE - Measure Signal

Hantek 6022BE
Measure Signal

Cursor

Measure
Cursor Menu
Click “Cursor” in main menu
This method allows you to take measurements by moving the cursors
1. Source
The user can set the source to CH1, CH2, FFT and MATH. But the FFT
source can only use Trace type.
When you use cursors, be sure to set the Source to the waveform on the
display that you want to measure.
2. Type
There are four types of cursors: Cross, Vertical and Horizontal
1) Cross
The Cross cursors appear as cross lines on the display and measure
the vertical and horizontal parameters.
37
The User’s Manual