Hantek 6022BE
on the rising or the falling edge of a signal. Select Edge trigger mode to
trigger on Rising edge or Falling edge.
Mode: Select the trigger mode.
The oscilloscope only provides
edge trigger mode.
Sweep: Set the sweep mode to Auto, Normal or Single.
Auto: Acquire waveform even no trigger occurred
Normal: Acquire waveform when trigger occurred.
Single: Acquire waveform when trigger occurred then stop
Source: You can use the trigger source options to select the signal that the
oscilloscope uses as a trigger. The source can be any signal
connected to a channel BNC, or to the EXT. BNC.
CH1: Select CH1 as trigger signal
CH2: Select CH2 as trigger signal
Slope: Set the slope to Rising (+) or Falling (-).
Rising: Trigger on rising edge
Falling: Trigger on falling edge
36
The User’s Manual
To Next Page
Loading...
