Need help?Do you have a question about the Hantek 1008 and is the answer not in the manual?
General| Channels | 8 |
|---|---|
| Vertical Resolution | 8 bits |
| Input Impedance | 1 MΩ |
| Input Coupling | DC, AC, GND |
| PC Interface | USB 2.0 |
| Power | USB Powered |
| Weight | 0.5 kg |
| Input Sensitivity | 10 mV/div to 5 V/div |
| Display | PC-based |
| Trigger Modes | Video |
| Operating System Compatibility | Windows XP/Vista/7/8/10 |
Details minimum and recommended computer configurations for the oscilloscope software.
Describes the steps for installing the Hantek1008 software from the CD-ROM.
Explains how to connect the USB cable and initiate driver installation for the device.
Explains how to match probe characteristics with the channel input for accurate readings.
Details the process for optimizing the oscilloscope's signal path for accurate measurements.
Explains the components of the Hantek1008 software user interface.
Covers setting up trigger modes, sweep, source, and slope for capturing events.
Details trigger mode, sweep, source, and slope for effective waveform capture.
To Next Page
