User can adjust the controls to meet your measurement to optimize the waveform
Simple Measurement
display.
To measure the frequency and “Vpp
”, you can do these steps as follows:
1. Click the “Measure->Horizontal->Frequency” button, the frequency of the signal
display on the bottom of the waveform interface.
2. Click the “Measure->Vertical->Peak-to-Peak” button, the “Vpp” of the signal will also
display on the bottom of the waveform interface.
3. To clear the measurement on the waveform interface, click the “Measure->Clear
Measure” button.
72
Hantek1008
To Next Page
Loading...
