Hantek 6022BE
Set Oscilloscope
Save Setup
The oscilloscope software saves the current setup before you close the
oscilloscope software. The oscilloscope recalls this setup the next time
you run the software. You can use the “Save Setup” menu to permanently
save up to several different setups.
Load Setup
The oscilloscope can recall the last setup before the oscilloscope software
was running, any saved setups, or the factory setup. You can use the
“Load Setup” menu to permanently recall a setup.
Factory Setup
The oscilloscope software is set up for normal operation when it is
shipped from the factory. This is the factory setup. To recall this setup,
push the “Factory Setup” menu.
Set Vertical Systems
The CH1/CH2 control panel in sidebar
23
The User’s Manual
To Next Page
Loading...
