1. In the case of DC current, the output is positive when the current flows from the upside
to the underside of the clamp. The red banana plug is positive.
2. In the case of DC current measurement, the current clamp can not possibly zero
properly, due to the hysteresis effect. To eliminate this, open and close the jaws several
times and then zero again.
APPLICATION SAFETY
1. The voltage of the conductor measured with the current clamp should be little than
300V DC or 240V rms AC,
2. We are forbidden to measure the conductor whose insulation has break down or wear
down, in order to avoid doing harm to us.
SPECIFICATIONS GENERAL
Captured Conductor diameter Size: 9mm maximum
Low Battery Indicator: Red LED lighting
Operating Temperature: 0℃ to 50℃, 70% R.H.
Storage Temperature: -20℃~+70℃, 80% R.H.
Battery type: 9V DC, NEDA 1604, 6F22, 006P
Battery Life: 100 hours typical with carbon-zinc
Weight: 250 gram typical
Dimensions: 195 mm (H) x 70 mm (W) x 33 mm (D)
Output: wire with a straight banana plug or BNC connector
ELECTRICAL (At 23±5℃, 70% R.H. maximum)
Efficient Measure Range:
1mV/10mA: 10mA to 2 A, multimeter range is set to DC or rms AC 200mV
1mV/100mA: 100mA to 20 A, multimeter range is set to DC or rms AC 200mV
20A to 65 A, multimeter range is set to DC or rms AC 2V
Precision:
System Accuracy: The Precision of the current clamp add the Precision of the digital
multimeter or scope.
For example, if the conductor carries 100 mA current, the current clamp range will be set
To Next Page
Loading...
