Basic Operation
DSO4000 Series Digital Storage Oscilloscope 48
2. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Wave Param:
Duty: The duty of the output wave.
Output: Select output type continuous or single.
Ext Trig: Turn on or turn off external trigger, select rise edge or falle dge.
Generate the Trapezia waveform
To output a Trapezia wave, please do the following steps:
1. Press F2 button to select "Trapezia".
2. Set the Wave Parameter:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Wave Param:
Rise Duty: Set the output wave rise duty.
High Duty: Set the output wave high duty.
Fall Duty: Set the output wave fall duty.
Output: Select output type continuous or single.
Ext Trig: Turn on or turn off external trigger, select rise edge or falle dge.
Generate the Exponent waveform
To output an Exponent Waveform, please do the following steps:
1. Press F2 button to select the wave "Exponent".
2. Set the Wave Parameters:
Frequency: Set the output wave frequency.
Amplitude: Set the output wave amplitude.
Y Offset: Set the output wave vertical level offset.
Output: Select output type continuous or single.
Ext Trig: Turn on or turn off external trigger, select rise edge or falle dge.
Wave Param:
Time: Set the ouput wave Tao param.
Ext Type: Set the output wave slope to rise or fall.
Generate the AM/FM waveform
To output an AM/FM Wave, please do the following Steps:
1. Press F2 button to select "AM/FM".
To Next Page
Loading...
