Basic Operation
DSO4000 Series Digital Storage Oscilloscope 50
1) Click “Wave Parameter->Parameter” to sewaveform frequency and poin number. The
maximum of point is 4096.
2) Click “Edit->Points Edit” to set pointindex and voltage. Also user can drag left mouse to
edit points.
3) Click “File->Save CSV”, and save CSV file to U disk or other paths.
4) Insert U disk to the USB port of the device, select wave as "Arb ". Then press "Recall"
menu to recall saved file. Use a test lcable connect the signal to the signal output terminal,
observe the output waveform figure as follows:
To Next Page