.%%($A)$(F"#5)(+6)5(<#%7)4#$A(+'54)
The cable is threaded around the large pulley and past the inner side of the small safety release pulley. Use some tie
wire to grab the cable and press on the cable from bottom with a bar or rod to flex the cable to where it is required to
fit through.
It may be easier to move the columns out during this process.
Figure: Using tie wire to pull the cable through, the tie wire is looped and with in away that it fits over the cable and
can pull it through.
Figure: The correctly threaded cable will look like this, the cable can then be pulled through to its full length.
To Next Page
Loading...