To Next PageTo Next PageHow to fix a Harbor Breeze TILGHMAN WCK52LMW5N that won't turn on?
If your Harbor Breeze Fan isn't moving, make sure the reverse switch is fully engaged by pushing it firmly either up or down. Check that the power is on and the fuse is working. Turn the power off and check all wire connections behind the canopy. Finally, check that the male and female plugs in the switch housing are properly connected.
Why is my Harbor Breeze Fan so noisy?
If your Harbor Breeze Fan is making noise, start by checking if all blade screws are tightened. If a blade is cracked, it should be replaced. Also, if you're using a full range dimmer switch, replace it with an approved speed control device. New fans may also require a "break in" period of a few days, especially at medium and high speeds.
What to do if my Harbor Breeze Fan is wobbling too much?
To fix excessive wobbling in your Harbor Breeze Fan, first, tighten all blade screws. Then, check that the blade arms are correctly attached. Try switching one blade with a blade from the opposite side to balance them. Turn the power off and check that the mounting bracket is secure. If the fan is too close to a vaulted ceiling, use a longer downrod or move the fan. Make sure the set screws on the motor housing yoke and the hanging ball are tightened securely.
General| Brand | Harbor Breeze |
|---|---|
| Model | TILGHMAN WCK52LMW5N |
| Type | Ceiling Fan |
| Blade Span | 52 inches |
| Number of Blades | 5 |
| Motor Type | AC |
| Number of Speeds | 3 |
| Reversible Motor | Yes |
| Light Kit Included | Yes |
| Light Type | LED |
| Control Type | Remote Control |
| Color | White |
| Indoor/Outdoor Use | Indoor |
| ENERGY STAR Certified | No |
| Blade Pitch (Degrees) | 12 |
Wiring diagram for controlling fan and light via pull chains.
Wiring diagram for controlling fan with pull chain, light with wall switch.
Wiring diagram for controlling fan and light via separate wall switches.
