What to do if my Harbor Breeze TEX52MBK5C1L Fan works but the light doesn't?
If your Harbor Breeze Fan operates but the light fails, check the wires in the canopy and re-wire if necessary. Ensure the wall switch to the fan is on. Check that the plugs are connected properly. Also, make sure the light kit is lamped with bulbs that allow the wattage total to be no more than 190W.
Why is my Harbor Breeze Fan wobbling so much?
If your Harbor Breeze Fan is excessively wobbling, start by tightening all blade screws. If that doesn't solve the problem, ensure the blade arms are correctly attached. Also, turn the power off and check if the mounting bracket is secure. Check that set screw(s) on motor housing yoke and set screw on hanging ball are tightened properly. If the fan is too close to a vaulted ceiling, consider using a longer downrod or moving the fan.
What to do if my Harbor Breeze Fan does not move?
If your Harbor Breeze Fan is not moving, first, make sure the reverse switch is fully engaged by pushing it firmly either left or right. Then, verify that the power is on and the fuse is working correctly. After that, turn the power off, loosen the canopy, and check all wire connections. Finally, check that male and female plugs in the switch housing are connected properly.
How to fix a noisy Harbor Breeze TEX52MBK5C1L Fan?
If your Harbor Breeze Fan is making noise, try tightening all the blade screws. If the noise persists, check for cracked blades and replace them if necessary. If you are using a full range dimmer switch, replace it with an approved speed control device. If the fan is new, allow it a “break in” period of a few days, especially when running the fan at Medium and High speeds.
Essential safety guidelines to follow before and during installation.
Details the estimated time required for product assembly.
Lists tools needed for assembly, which are not included with the product.
Instructions to shut off electricity at circuit breakers and wall switch.
Guides on choosing between standard and angle mounting for the fan.
Ensures adequate space between fan blades and floor/obstructions.
Instructions for attaching the mounting bracket to the outlet box.
Removing pin and clip, loosening set screws for downrod installation.
Threading wires and attaching downrod through canopy parts.
Wiring instructions for dual control via pull chains.
Wiring for fan controlled by pull chain, light by wall switch.
Wiring for separate control of fan and light via two wall switches.
Securing the canopy to the mounting bracket and attaching the canopy cover.
Instructions for attaching blade arms to fan blades using screws and washers.
Attaching blade arms to the motor housing using motor screws and lock washers.
Connecting the switch housing plate to the motor housing.
Securing the motor plate and switch housing plate to the motor housing.
Connecting the light kit fitter to the switch housing.
Removing finial, plate, and washer from light kit fitter rod.
Installing 60-watt bulbs into the light kit fitter sockets.
Securing the glass shade to the light kit fitter using threaded washer and finial.
Connecting pull chain extensions to the fan and light pull chains.
Disconnecting the light kit wires from the switch housing.
Placing the cap in the switch housing hole.
Connecting the motor plug to the switch housing female plug.
Attaching the switch housing to the switch housing plate.
Using the fan pull chain to control fan speed (High, Medium, Low, Off).
Using the light pull chain to control light output (On/Off, Downlight).
Adjusting the fan for seasonal airflow (downward for cooling, upward for heating).
Checking screws and cleaning the fan and blades with lint-free cloth.
Guidelines for replacing downlight and uplight bulbs, including wattage limits.
Causes and corrective actions for a fan that is not operating.
Identifying causes of noise and how to fix them, including break-in period.
Troubleshooting steps for fan wobbling, including checking screws and mounting.
Diagnosing issues where the fan works but the light does not.
General| Brand | Harbor Breeze |
|---|---|
| Model Number | TEX52MBK5C1L |
| Type | Ceiling Fan |
| Blade Span | 52 inches |
| Number of Blades | 5 |
| Motor Type | AC Motor |
| Number of Speeds | 3 |
| Reversible Motor | Yes |
| Light Kit Included | Yes |
| Light Type | LED |
| Control Type | Remote Control |
| Mounting Options | Downrod mount |
| Color | Matte Black |
| Indoor/Outdoor Use | Indoor |
To Next Page