Page 17<&(%$*4.8"4,7%H'*#$"&8#I%/7*,#*%4,77%JKLLLKLMMKNOPO1Item 56825
?@<6AQD@CEA6E@ER6 S@?CR%T6GUCEVT6GUCEV%ACW? SETUP
After practice welding on scrap, stop,
and check your progress. Perform
Strike Test according to ?$("Y*%A*#$%&8%
/,3*%b^1 After making any necessary
adjustments, continue to weld while
carefully following the DUTY CYCLE
guidelines as explained on page 14.
T@;ECEVc%%AX%W;6!6EA%?6;CXF?%CE`F;Q- D*$,7%
)&(Y%+*84.%5'#$%+*%3(&'89*9%).*8%ACV%)*79"83%
VHH+LJK)UHTXHQF\*URXQGLQJRQSDJH
8. Hold TIG Torch in one gloved hand and
the TIG Rod in other gloved hand.
9. Specific Welding Techniques:
B"3.%<(*H'*84>%?$,($%
• Hold Torch away from the workpiece
the same distance as 1 to 1.5 times the
diameter of the Tungsten Electrode.
• Press Foot Pedal down slowly until arc
ignites. Then, press Foot Pedal down all
the way to reach maximum amperage. Let
up on Foot Pedal to lower amperage.
EXA6- Maintain a constant distance between the
Tungsten Electrode and the workpiece: between
1 and 1.5 times the diameter of the Electrode.
10. When welding puddle is hot enough, tilt torch
backward about 10-15 degrees from vertical and
move it back slightly. Add TIG Rod material as
needed to the front end of the weld puddle.
11. Alternate between pushing the torch/weld
puddle and adding the TIG Rod material.
EXA6- Back the TIG Rod off each time the Electrode
is advanced, but do not remove it from the gas shield.
This prevents oxidation from contaminating the weld.
12. When finished welding, release the Foot Pedal, but
keep Torch on weld puddle until gas flow ends.
13. Set TIG Torch down on nonconductive,
nonflammable surface away from
any grounded objects.
14. Turn the Current Output Knob to the lowest
setting, then turn the Power Switch off.
15. To prevent accidents, after use:
• Allow Welder to cool down.
• Unplug Welder’s power cord from outlet.
• Remove Ground Clamp from workpiece or table.
• Disconnect TIG Torch, Ground
and Foot Pedal Cables.
• Close gas cylinder’s valve securely,
remove regulator and replace cap.
• Disconnect Gas Hose from Welder.
• Store and secure gas cylinder.
• Clean, then store Welder and its accessories
indoors out of children’s reach.
To Next Page
Loading...
