EZ-Guide® Plus
Problem Possible cause Solution
A single LED is The ambient temperature If it is cold, turn on the heater in the cab.
flashing is outside the lightbar If it is hot, turn on the air conditioning.
temperature range If sun is shining directly on the lightbar, shade the lightbar from the sunlight.
he lightbar is not The suction cup is a Pump the suction cup each day or when the red line appears.
securely mounted temporary mounting Glue the suction cup to the window. Mount the lightbar bracket
device directly on the dash, ceiling, or window.
For more information, see page 3.
Coverage area value Guidance was not Always pause guidance before disconnecting
is not saved over a paused before power
power cycle was disconnected.
power.
he lightbar will not The lightbar will not work To enable normal operation, reduce the temperature of the
work after lunch if it gets too hot. Do not lightbar by turning on the vehicle air conditioning or shielding
leave the lightbar in a the lightbar from direct sunlight.
place that may become
very hot, such as in
direct sunlight, when you
take a break.
29
To Next Page
Loading...