Need help?Do you have a question about the Hardi HC 8600 and is the answer not in the manual?
General| Type | Controller |
|---|---|
| Model | HC 8600 |
| Manufacturer | Hardi |
| GPS Compatibility | Yes |
| Section Control | Yes |
| Power Supply | 12 V DC |
| Protection Rating | IP65 |
| Display | 12.1 inch Touchscreen |
| Communication | CAN bus |
Explains safety symbols, general precautions, and safe operating practices for sprayer use.
Details the rear and front/side components of the display unit.
Instructions for installing and mounting the display unit securely within the vehicle cab.
Diagrams illustrating various cable connections for ISOBUS and non-ISOBUS tractors.
Lists components of the RAM mount kit for display installation.
Details cable connections for ISOBUS tractors with cabin connectors.
Details cable connections for ISOBUS tractors without cabin connectors.
Guides through the initial setup wizard for new displays, including advanced options.
Enables and configures Universal Terminal and Task Controller for ISOBUS compatibility.
A step-by-step guide for a quick and easy start with the HC 8600/9600 controller.
Steps to configure the system for trailer and lift sprayer types.
Steps to configure the system for self-propelled sprayer types.
Guides on creating and configuring products and product mixes.
Defines full, basic, and custom permission levels for operators and managers.
Configures the sprayer's speed source for accurate operation and data logging.
Manages automatic section on/off based on boundaries and coverage, including look-ahead settings.
Defines machine's rear axle and hitch position relative to the GPS antenna for accurate mapping.
Setup for GPS guidance systems, including steering, receiver, and operator presence alarms.
Configuration for RTK external and NTRIP connections, including radio settings and network parameters.
Configures channel spacing and frequency for 400 MHz and 900 MHz RTK.
Guides on creating straight AB lines for guidance patterns using two points.
Guides on creating adaptive curve patterns for field contours or obstacles.
Guides on creating identical curve patterns for following gentle contours.
Guides on creating pivot patterns for irrigated fields with center-pivots.
Guides on creating guidance patterns for irregular fields using previously driven passes.
Guides on creating and managing application products and product templates.
Steps to set up a tank mix with multiple components and define its properties.
Defines mix contents, amounts, activating/deactivating products, and changing rates.
Steps to create and load system configurations for vehicles and implements.
Configures settings related to rate outside of field, display smoothing, and rate change look-ahead.
Overview of the configuration setup screen and its various tasks.
Interface for managing application rates, product settings, and prescriptions.
Adjusts rate settings, imports prescriptions, and configures minimum flow.
Procedure for loading map-based prescription files for variable rate application.
Adjusts application rates, container levels, and imports prescriptions.
Displays field totals and averages, with filtering and viewing mode options.
Creates and views documentation of in-field application events saved as PDFs.
Details the content of product application reports, divided into field and product-specific information.
Troubleshooting ISOBUS Universal Terminal issues, object pool loading, and implement C2C connectivity.
To Next Page
