Page 38 of 87
Software program for the controller
The software sent in a mail as Zip file.
The Zip file must be unpacked and put into
a folder.
The top file (HardiExeUploadWinvxxx.exe)
is the upgrade program.
The two other files (xxx.bin) are the
software for the controller and the JobCom.
This example show HC5500 software file
“HardiV316.bin” with software version is
3.16.
The JobCom reads “HardiJCV1.11.bin”
with software version 1.11.
Note: It is very important that these three
files are in the same folder at all time
otherwise will the upgrade program not
work.
Run Hardi HC Upgrade, double click on
HardiExeUploadWin.exe and you will get a
window like this:
How to use the Hardi upgrade program is
described in section “Software upload
HC5500” and “Software upload JobCom”.
A: Information about the current
version of Hardi HC Upgrade.
B: Here you do a complete serial port
scan
C: Shows the software available for
upgrade.
D: Here you select the comport, which
is connected to the unit you use.
E: Check this button if you wish to use
high-speed transfer, this is only
possible with a “CP210x USB to
UART Bridge Controller” and only
together with HC6500.
F: Connect and upgrade unit.
G: Exit program.
To Next Page
Loading...
Need help?
General
