Hardi MASTER TWIN STREAM - Control Boxes and Power Supply

GB 05 02 02 MA
Sprayer setup
ContrContr
ContrContr
Contr
ol bool bo
ol bool bo
ol bo
xx
xx
x
es and powes and pow
es and powes and pow
es and pow
er supplyer supply
er supplyer supply
er supply
ContrContr
ContrContr
Contr
ol bool bo
ol bool bo
ol bo
xx
xx
x
eses
eses
es
Control boxes are fitted in the tractor cabin at a conven-
ient place. Tapping screws can be used for mounting.
Power supply
Power requirement is 12V DC. Note polarity!
The wires must have a cross sectional area of at least
4.0 mm to ensure a sufficient power supply. For the EVC
operating unit the tractor circuit should have an 8 Amp
fuse
Control box Polarity (wire colour) Fuse (Amp)
Positive + Negative -
EVC control unit Brown Blue 8
T102-0022
GenerGener
GenerGener
Gener
al infal inf
al infal inf
al inf
ormaorma
ormaorma
orma
tiontion
tiontion
tion
Ensure that snap couplers are clean before connection!
NOTE! The hydraulic system requires a minimum
oil pressure of 100 bar and an oil capacity of
approx. 2 litres.
After having operated the boom and the system has
been filled with oil, check tractor’s hydraulic oil level and
top up if necessary.
SafSaf
SafSaf
Saf
ety infety inf
ety infety inf
ety inf
ormaorma
ormaorma
orma
tiontion
tiontion
tion
WARNING! Test of the hydraulic system should
be done very cautiously. There may be air trapped
in the system which can cause violent move-
ments of the boom.
WARNING! Hydraulic leaks. Never use your
fingers to locate a leakage in any part of the
hydraulic system. Due to high pressure, hydraulic
oil may penetrate the skin.