GB 14 00 MA
Maintenance
T180-0003
4. Nozzle f4. Nozzle f
4. Nozzle f4. Nozzle f
4. Nozzle f
ilterilter
ilterilter
ilter
ss
ss
s
Check and clean.
5. Spr5. Spr
5. Spr5. Spr
5. Spr
aa
aa
a
ying cirying cir
ying cirying cir
ying cir
cuitcuit
cuitcuit
cuit
Fill with clean water, operate all functions and check for
leaks using higher spray pressure than normal. Check
nozzle spray patterns visually using clean water.
T180-0004
T180-0005
T180-0006
10 hour 10 hour
10 hour 10 hour
10 hour
s sers ser
s sers ser
s ser
vicevice
vicevice
vice
1. Suction f1. Suction f
1. Suction f1. Suction f
1. Suction f
ilterilter
ilterilter
ilter
To service the suction filter:
1. Pull out the steel clip A.
2. Lift the suction hose fitting
B from housing.
3. Filter guide and filter C
can now be removed.
To reassemble:
4. Press the guide onto filter end.
5. Place the filter into housing
with guide facing up.
6. Ensure the O-ring D on the
hose fitting is in good
condition and lubricated.
7. Refit the suction hose B
and steel clip A.
2. Self-Cleaning F2. Self-Cleaning F
2. Self-Cleaning F2. Self-Cleaning F
2. Self-Cleaning F
ilterilter
ilterilter
ilter
1. Unscrew nut A and open filter.
2. Check filter gauze B, clean if necessary
3. Lubricate O-ring C
4. Assemble filter again.
3. In-Line f3. In-Line f
3. In-Line f3. In-Line f
3. In-Line f
ilter (ifilter (if
ilter (ifilter (if
ilter (if
f f
f f
f
itted)itted)
itted)itted)
itted)
If the boom is equipped with In-Line Filters
unscrew the filter bowl to inspect and
clean the filter.
Alternative filters are available. See
section on Technical specifications - Filters
and nozzles.
To Next Page
Loading...
Need help?
General
