FRONT-PANEL CONTROLS
Surround Mode
: Press this button to select a surround sound (e.g.,
multichannel) mode. Each press changes the surround mode category:
AUTO SELECT, VIRTUAL, STEREO, MOVIE, MUSIC, VIDEO GAME. To change the
specific mode within the category, use the Surround Select Buttons. See the
Advanced Functions section for more information on surround modes.
Surround Select
: After you have selected the desired surround mode
category, press these buttons to select a specific mode within the category,
such as to change from Dolby Pro Logic IIx Movie mode to Logic 7 Movie
mode. Surround mode availability depends on the nature of the source input
signal, i.e., digital versus analog, and the number of channels encoded within
the signal.
Source Selectors
: Press this button to select a source device, which is a
component where a playback signal originates, e.g., DVD.
Headphone Jack / EzSet/EQ Microphone Input
: Plug a 1/4" (6,3
mm) stereo headphone plug into this jack for private listening.
This jack is also used to connect the supplied microphone for the EzSet/EQ
procedure described in the Initial Setup section.
Digital Audio Inputs (Optical 3 and Coaxial 3)
: Connect a source
component that will only be used temporarily, such as a digital camera or
game console, to these jacks. Use only one type of audio. The audio input may
be assigned to any video source.
USB Port
: This port may be used in case a software upgrade for the receiver
is offered in the future. Do not connect a storage device, peripheral product or
a PC here, unless instructed to do so as part of an upgrade procedure.
Video 3 Analog Audio and Video Inputs
: Connect a source
component that will only be used temporarily, such as a digital camera or
game console, to these jacks. These inputs are selected as the Video 3 source,
and may not be assigned to other sources.
Volume Knob
: Turn this knob to raise or lower the volume.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
