Need help?Do you have a question about the Harman Kardon AVR 100 and is the answer not in the manual?
Audio Specifications| stereo mode power | 50 Watts per channel, 20Hz–20kHz, < 0.08% THD, 8 ohms |
|---|---|
| five-channel surround mode power (front channels) | 40 Watts per channel, < 0.08% THD, 20Hz–20kHz, 8 ohms |
| five-channel surround mode power (center channel) | 40 Watts, < 0.08% THD, 20Hz–20kHz, 8 ohms |
| five-channel surround mode power (surround channels) | 40 Watts per channel, < 0.08% THD, 20Hz–20kHz, 8 ohms |
| input sensitivity/impedance | 250mV/47k ohms |
| signal-to-noise ratio (IHF-A) | 90dB |
| frequency response | 10Hz–100kHz @ 1W (+0dB, –3dB) |
| high instantaneous current capability (HCC) | ±30 Amps |
| transient intermodulation distortion (TIM) | 0.08% (20Hz – 20kHz) |
| rise time | 16 µsec |
| slew rate | 40V/µsec |
FM Tuner Specifications| frequency range | 87.5–108MHz |
|---|---|
| usable sensitivity | 1.5µV/14.8dBf |
| signal-to-noise ratio mono/stereo | 73/70dB |
| distortion mono/stereo | 0.3/0.5% |
| stereo separation | 40dB @ 1kHz |
| selectivity | ±400kHz, 60dB |
| image rejection | 40dB |
| IF rejection | 100dB |
| tuner output level | 500mV @ 1kHz, ±75kHz Dev |
AM Tuner Specifications| frequency range | 520–1710kHz |
|---|---|
| signal-to-noise ratio | 35dB |
| usable sensitivity | 800µV/M |
| distortion | 1kHz, 50% Mod 1.5% |
| selectivity | ±10kHz, 30dB |
Video Specifications| video format | NTSC |
|---|---|
| input level/impedance | 1Vp-p/75 ohms |
| output level/impedance | 1Vp-p/75 ohms |
| video frequency response | 10Hz–8MHz (–3dB) |
General Specifications| power requirement | AC 120V/60Hz |
|---|---|
| power consumption | 72W idle, 290W maximum (2 channels driven) |
| width | 17.3 inches (440mm) |
| height | 6.2 inches (156mm) |
| depth | 14.7 inches (375mm) |
| weight | 27.9 lb (12.6 kg) |
Configure speaker types and determine optimal placement for sound reproduction.
Calibrate speaker output levels using test tones for proper surround sound.
Adjust audio delay times to synchronize sound arrival from different speakers.
Select from various surround sound modes for different audio sources.
Program the remote using three-digit codes for different devices.
Automatically find and program remote codes when direct entry fails.
Reset the AVR's memory to clear configuration data and resolve issues.
To Next Page