AVR 7200 AUDIO/VIDEO RECEIVER
3 Introduction
4 Important Safety Information
4 Unpacking
5 Front-Panel Controls
7 Front-Panel Information Display
8 Rear-Panel Connections
11 Main Remote Control Functions
14 Zone II Remote Control Functions
15 Installation and Connections
18 System Configuration
18 Speaker Placement
18 System Setup
19 Input Setup
20 Surround Setup
21 Speaker Setup
23 Delay Settings
24 Output Level Adjustment
24 Using EzSet
™
25 Manual Output Level Adjustment
27 Operation
27 Basic Operation
27 Remote Control Operation
27 Source Selection
28 6-Channel/8-Channel Direct Input
28 Volume Control
28 Surround Mode Selection
29 Surround Mode Chart
30 Digital Audio Playback
32 Tuner Operation
32 Recording
32 Front-Panel Connections
33 Output Level Trim Adjustment
34 Advanced Features
34 Surround Amplifier Channel Assignment
34 Display Brightness
34 Turn-On Volume Level
34 OSD Settings
36 Multiroom Operation
36 Multiroom Setup
36 Multiroom Operation
38 Configuring the Remote
38 Preprogrammed Code Entry
39 Automatic Code Entry
39 Learning Commands
40 Changing Devices
41 Macro Programming
42 Punch-Through Configuration
43 Volume Punch-Through
43 Channel Punch-Through
44 Transport Punch-Through
44 EzSet Configuration
45 Renaming
46 Resetting the Remote
48 Troubleshooting Guide
48 Processor Reset
49 Technical Specifications
49 Trademark Acknowledgements
2 TABLE OF CONTENTS
Typographical Conventions
In order to help you use this manual with the remote control, front-panel controls and rear-panel connections,
certain conventions have been used.
EXAMPLE – (bold type) indicates a specific remote control or front-panel button, or rear-panel
connection jack
EXAMPLE – (OCR type) indicates a message that is visible on-screen or on the front-panel
information display
EXAMPLE – (Synchro type) indicates a message that is displayed on the remote control’s LCD screen
1 – (number in a square) indicates a specific front-panel control
¡ – (number in a circle) indicates a rear-panel connection
a – (number in an oval) indicates a button or indicator on the remote
A – (letter in a square) indicates an indicator in the front-panel display
å
– (letter in an oval) indicates a button on the Zone II remote
AVR 7200 OM 1/27/03 4:46 PM Page 2
To Next Page
Loading...
Need help?
General
