EasyManuals Logo

Harman Kardon AVR35RDS User Manual

Harman Kardon AVR35RDS
40 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
Rear Panel Connections
10
AVR35RDS 230 volt Rev (C) 9/28/98
Front: Connect these terminals
to the front left/right speakers.
ª Center: Connect these terminals
to the center speaker.
Surrounds: Connect these
terminals to the surround speakers.
Switched AC Outlet: This outlet
may be used to power any device
that you wish to have turn on when
the unit is turned on with the System
Power Control switch 2.
¤ Unswitched AC Outlet: This
outlet may be used to power any AC
device. The power will remain on at
this outlet regardless of whether the
AVR35RDS is on or off.
NOTE: The power consumption of
the device plugged into each of
these outlets should not exceed
100 watts.
Power Cable: Connect the AC
plug to a non-switched AC wall
output.
Video 2 Inputs: Connect these
jacks to the audio and video outputs
of a TV Tuner, Cable TV converter
box, satellite receiver or any other
audio/video source.
TV Monitor Video Output:
Connect this jack to the standard
(composite) video input of a TV
monitor or video projector to view
the on-screen menus and the
output of any standard video source
selected by the receiver’s video
switcher.
AC-3/PCM Coaxial Input:
Connect the coax digital output from
a DVD player, HDTV receiver, LV
player or CD player to this jack. The
signal may be either a Dolby Digital
(AC-3) signal or a standard PCM
digital source.
AC-3/PCM Optical Input:
Connect the optical digital output
from a DVD player, HDTV receiver,
LV player or CD player to this jack.
The signal may be either a Dolby
Digital (AC-3) signal or a standard
PCM digital source.
° Remote IR In: If the AVR35RDS’s
front panel IR sensor is blocked due
to cabinet doors or other obstruc-
tions, an external IR sensor may be
used. Connect the output of the sen-
sor to this jack.
· Remote IR Out: This connection
permits the IR sensor in the receiver
to serve other remote controlled
devices. Connect this jack to the “IR
IN” jack on Harman Kardon or other
compatible equipment.
a Tape Monitor In: Connect these
jacks to the PLAY/OUT jacks of an
audio recorder.
b Tape Monitor Out: Connect
these jacks to the RECORD/INPUT
jacks of an audio recorder.

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Harman Kardon AVR35RDS and is the answer not in the manual?

Harman Kardon AVR35RDS Specifications

General IconGeneral
BrandHarman Kardon
ModelAVR35RDS
CategoryReceiver
LanguageEnglish

Related product manuals