Front Panel Controls
& Preset Stations Selector: Press
this button to select stations that
have been entered into the preset
memory. (See page 26 for more
information on tuner programming.)
* RDS Button: Press this button
to display the various messages
that are part of the RDS data system,
or to begin a search for a specific
PTY type. (See page 26 for more
information on RDS.)
( Dolby Digital Selector: Press
this button to select the Dolby Digital
surround mode when listening to a
program that carries the Dolby
Digital information. (See pages 22-25
for more information on surround
modes and digital audio.)
Ó Dolby Pro Logic Selector: Press
this button to select the Dolby Pro
Logic surround mode when listening
to an analog program that is encoded
with surround-sound information. (See
pages 22–25 for more information on
surround modes.)
Ô Dolby 3 Stereo Selector: Press
this button to select the Dolby 3
Stereo listening mode. This mode is
used primarily when a program has
surround information when a center
channel speaker, but no surround
speakers, is installed. (See pages
22–25 for more information on
surround modes.)
Analog Surround Mode
Selectors: Press one of these
buttons to select the analog sur-
round modes. These modes may
be used with any analog program
source to create a pleasing surround
effect. (See pages 22–25 for more
information on surround modes.)
Ò Test Tone: Press this button to
begin the sequence of steps used
to set the AVR35RDS’s output levels.
When this button is pressed, a test
tone will replace the currently
selected listening source. (See page
19 for more information on using the
test tone to set the output levels.)
Ú Surround Off: Press this button
to turn off all surround processing,
and to listen to a program in tradi-
tional stereo from the left front and
right front speakers only.
Û Mute: Press this button to
momentarily silence the speaker
output of the AVR35RDS.
Ù Volume Control: Turn the knob
clockwise to increase volume,
counterclockwise to decrease the
volume.
ı Delay: Press this button to begin
the sequence of steps required to
enter delay time settings. (See page
20 for more information on delay
times.)
ˆ Digital Input Selector: When
playing a source that has a digital
output, press this button to select
between the Optical ‡ and Coaxial
fl Digital inputs. (See pages 22–25
for more information on digital audio.)
˜ Set Button: When making
choices during the setup and config-
uration process, press this button to
enter the desired setting, as shown
in the Information Display
33
, into
the AVR35RDS’s memory. (See
pages 17–24 for more information on
setup and configuration.)
¯ Channel Select: Press this
button to begin the process of
selecting and configuring the
AVR35RDS’s output channels. (See
pages 17–24 for more information
on setup and configuration.)
˘ Speaker Select Button: Press
this button to begin the process of
selecting the speaker positions that
are used in your listening room. (See
pages 17–24 for more information on
setup and configuration.)
¸ Selector Buttons: When you are
establishing the AVR35RDS’s config-
uration settings, use these buttons to
select between the choices avail-
able, as shown in the Information
Display
33
.
33
Information Display: This
display delivers messages and
status indications to help you
operate the receiver. (See page 7
for a complete explanation of the
Information Display.)
34
Remote Sensor Window: The
sensor behind this window receives
infrared signals from the remote con-
trol. Aim the remote at this area and
do not block or cover it unless an
external remote sensor is installed.
6
AVR35RDS 230 volt Rev (C) 9/28/98
To Next Page
Loading...
