AVR8000 IR RECEIVER/SENSOR - REMOVE AND REPLACE
Caution: Must use ESD procedures (grounding wrist strap) at all times to prevent microprocessor
damage!
1) Unplug any external connected cables to the AVR8000.
2) Remove the top cover, (18) black Phillips screws.
3) Remove all front panel assembly (11) screws.
4) Cut plastic wire ties (2) on top left section of front panel assembly.
5) At top left corner of chassis, remove the (2) screws holding (2) wires and metal bracket.
6) Remove (2) screws holding ground lugs to top left front heat sink.
7) Remove (1) plug consisting of red and black wires from AC switch.
8) Remove (2) screws holding mounting bracket for Headphone assembly.
9) Lay front panel assembly face down on a soft cloth to protect from damage.
10) Remove all (14) screws holding display PCB to front panel assembly.
11) Remove and replace IR Receiver RM701, h/k part#
55155930NR, located just below the display tube
on the left side.
12) Follow instructions in reverse order to reassemble. Replace cable ties where necessary.
AVR8000
harman/kardon
To Next Page
Loading...
