Harman AMX PR-WP-412 - Page 55

55
NOTE: "get switch
CO" command
response as "get
switch AO" and "get
switch VO" for
PR-WP-412 under
Matrix Mode, as its
audio and video can
be routed
independently
NOTE: "get switch
CO" command isn't
supported for
PR-WP-412 in
Windowing Mode
▪get switch video from no input for output 2
▪get switch audio from input 1 for output 2
▪get switch video from input 1 for output 2
▪get switch audio from no input for output 2
For PR-WP-412, Windowing Mode
▪no support in windowing video mode
10. set switch CI<input
channel>O<channel>
Set switch both the
audio and video
input to the output
port.
NOTE: "set switch
CI" command isn't
supported for
PR-WP-412 in
Windowing Mode
NOTE: "set switch
CI" command isn't
supported set input
channel to None
(input channel = 0)
for PR-WP-412 in
Matrix Mode
<input channel>=
{
0 for Selection of No
input channel,
1~4 for PR-WP-412
input channel
}
<output channel>=
{
0 for Selection of No
channel,
1~2 for PR-WP-412
Output Channel
under Matrix Mode,
all for Selection of
ALL channel
}
Possible command sent:
▪set switch CI1OALL
▪set switch CI0O1
▪set switch CI0O1,2
▪set switch CI2O0
Possible response message includes:
▪set switch audio and video from input 1 for all output
▪set switch audio and video from no input for output 1
▪set switch audio and video from no input for window 1
▪set switch audio and video from no input for output
1,2
▪set switch audio and video from input 2 for window
1,2,3
▪set switch audio and video from input 2 for no output
▪invalid switch
11. get switch AI<input
channel>
Get which audio
outputs is switched
to specified audio
input
<input channel>=
1~4
Command sent:
>get switch AI1
Possible response message includes:
▪get switch audio from input 1 for all output
▪get switch audio from input 1 for no output
▪get switch audio from input 1 for output 1
▪invalid