Control panel
11
Key combination shortcuts
The following control panel key combinations have special functions:
• Hold the MENU button pressed in – opens a shortcut menu with two menu items:
- RESET ALL
- ROTATE DISPLAY
• Hold the MENU button pressed in and press the UP button – makes the fixture carry out a reset.
• Hold both the MENU and ENTER buttons pressed in when you apply power to the fixture – puts the fixture
into Service mode (pan and tilt motors powered off, head can be moved freely by hand). To take the
fixture out of Service mode, power the fixture off and then apply power normally.
• Hold both the UP button pressed in and press the DOWN button – rotates the display 180°.
Settings stored permanently
The following settings are stored permanently in the fixture memory and are not affected by powering the
fixture off and on or by updating the fixture software:
• DMX address
• Fixture ID
• All personality settings (pan/tilt, cooling mode, dimming curve, display settings etc.)
• Resettable counters
• Service settings
Using the control panel on battery power (ERA 600 Profile)
The ERA 600 Profile contains a lithium battery that lets you use the control panel to set up the fixture even
when it is not connected to mains power.
All the main setup options in the control panel are accessible on battery power but the DMX LIVE and
MANUAL CONTROL menus are not available.