Harman Martin ERA 600 Performance - Control Panel Menus

26 ERA 600 Performance / Profile User Guide
Control panel menus
ERA 600 Performance / Profile firmware version 2.3.0.
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
DMX SETUP DMX ADDRESS 1 – XXX
DMX address (default address = 1). The
DMX address range is limited so that the
fixture will always have enough DMX
channels within the 512 available.
PERSONALITY
PAN INVERSE NO/YES Inverse DMX pan control: right → left
TILT INVERSE NO/YES Inverse DMX tilt control: down → up
PAN/TILT SPEED
FAST Optimize pan/tilt movement for speed
SLOW
Optimize pan/tilt movement for
smoothness
DIMMER CURVE
LINEAR Optically linear dimming curve
SQUARE LAW Square law dimming curve
INV SQ LAW Inverse square law dimming curve
S-CURVE
S-curve (fixture emulates incandescent
lamp voltage linear RMS dimming curve)
DIMMING SPEED
FAST Snap dimmer reaction
SLOW
Short crossfade when dimmer value
changes
NO DATA MODE
BLACKOUT If data signal stops, fixture blacks out
HOLD
If data signal stops, fixture holds last
received data on all channels (holds
current scene)
COOLING MODE
REGULATED FANS
Fan speed optimized for light intensity:
temperature-controlled by regulating
fan speed, light output unaffected as
long as ambient temperature is within
specified range, max. 40° C (104° F)
FULL Fans run at constant full speed
THEATER MODE
Low-noise mode. Maximum output limited
to 70%, fans set to Regulated, PWM
frequency set to 1200 Hz.
DISPLAY
DISPLAY
ROTATION
NORMAL /
ROTATE 180
Display orientation normal or rotated 180°
DISPLAY
INTENSITY
10 ... 100 % Set display intensity in % (default = 100)
TEMPERATURE
UNIT
°C / °F
All temperature readouts in Celsius /
Fahrenheit
DEFAULT
SETTINGS
FACTORY
DEFAULT
LOAD
ARE YOU SURE?
YES/NO
Return all settings (except calibrations) to
factory defaults
FIXTURE TEST
TEST ALL TESTING
Run test sequence of all LEDs and all
effects
TEST DIMMER DIMMER
Run dimming test sequence. Press Enter
to pause and to restart test sequence.
Press Menu button to exit test
TEST EFFECTS
CYAN
...
BLADE 4 ANGLE
Run test sequence of effects.
To test a specific effect, use Up/Down
buttons to scroll to effect. Press Enter to
pause and restart test sequence.
Press Menu button to exit test
TEST PAN/TILT
PA N
Run test sequence of pan functions.
Press Menu button to exit test
TILT
Run test sequence of tilt functions.
Press Menu button to exit test
Table 3: Control menus