Control panel menus
27
* See the fixture’s Safety and Installation manual for full details of the SERVICE control menu functions
INFORMATION
POWER ON TIME 0 ... XXXH
Display number of hours fixture has been
powered on since manufacture (not
user-resettable)
LED HOURS 0 ... XXXH
Display number of hours LEDs have been
powered on since manufacture (not
user-resettable)
SW VERSION V.X.X.X
Displays currently active fixture software
(firmware) version
FIXTURE ID 0000 - 9999
User-settable ID number. Use Up and
Down buttons to scroll to the chosen ID
number. Use Enter to confirm.
RDM UID 4D50XXXXXXXX Displays fixture’s unique RDM ID
TEMPERA-
TURES
LED / BASE
Scroll through current readings on all PCB
temperature sensors
FIXTURE TYPE
ERA 600 PERFORMANCE /
ERA 600 PROFILE
Displays the configuration that the
firmware has recognized: Performance or
Profile
DMX LIVE
STROBE
...
PAN/TILT SPEED
0 - 255
Scroll to see values currently being
received on each DMX channel
MANUAL
CONTROL
RESET
ALL Reset fixture
PAN / TILT Reset pan and tilt only
EFFECTS Reset effects only
STROBE
...
TILT FINE
Scroll through effects, then manually
control an effect
SERVICE*
PA N / TI LT
FEEDBACK
ON
Enable pan/tilt position feedback
system
OFF Disable pan/tilt position feedback system
CALIBRATION
PA N
...
BLADE4 ANGLE
(in Performance
fixtures) or
FOCUS
(in Profile fixtures)
-127 – +128
...
-127 – +128
Scroll through effects, press ENTER to
select effect. Adjust home position from
-127 to +128 and press ENTER to confirm
the new custom setting.
Important! If you want to keep custom
settings you must apply a SAVE SETTING
→
SAVE command before you leave the
CALIBRATION menu.
LOAD DEFAULTS
LOAD Load the factory default calibration settings
SAVE
Save current custom calibration settings
as default settings.
Important! Applying LOAD DEFAULTS →
SAVE and confirming with SAVE
SETTING → SAVE will permanently
overwrite the factory default calibration
settings and should normally be used by
Martin Service only!
SAVE SETTING SAVE
Confirm any changes made to calibration
values and any changes made in the
LOAD DEFAULTS and CLEAR ALL
VALUES menus
CLEAR ALL
VALUES
RESTORE
Reset all calibration values to zero.
Important! Applying CLEAR ALL VALUES
→ RESTORE and confirming with SAVE
SETTING → SAVE will permanently
overwrite the factory default calibration
settings and should normally be used by
Martin Service only!
USB UPDATING FILES
ERA600 1.1.0
...
ERA600 X.X.X
Displays firmware upload status
Menu level 1 Menu level 2 Menu level 3 Menu level 4 Notes (Default settings in bold print)
Table 3: Control menus
To Next Page
Loading...
