Harman PF100 - Page 5

5
3-90-08101R23_06/13
Assembly
Assembling Filter Box, Cont’d
3.Placethelterframepanelinsidethebottomandinside
thesolidpanelcorner.SeeFig.6forcornerdetail.Make
surethatthelteropeningisup.SeeFig.5Holdthelter
paneltothesolidpanelwithaTekscrewinthemiddle
holeofthesolidpanel,andoneinthebottommiddlehole
underthelteropening.
NOTE: Do not put any screws into any of the top holes
at this time.
Fig. 5
Filter Frame Panel
Filter opening must be up
Fig. 7
Open Side Panel
Fig. 6
4.Placetheremainingpanel,(inthiscasethebloweraccess
panel)inthebottompanelandintothecornerofthesolid
panel.SeeFig.7.Makesurethatthepanelisintheupright
position.Therearenocovermountingholesinthebottom
edgeofthispanel.HoldthepanelintoplacewithoneTek
screwinthemiddleholeofthesolidpanelandoneinthe
bottommiddleholeofthebloweraccesspanel.