User Manual
8.7: CLR & ALT+CLR
MIX FEATURES > CLR & ALT+CLR
8.7: MIX FEATURES > CLR & ALT+CLR
CLR + GEQ HI/LO (FADERS)
Reset all Graphic EQ levels to 0dB for the currently selected channel. Only works where GEQ is available (output /
bus channels).
CLR + tOTEM (FADER FOLLOW) button
Reset all contributions and ON status from channels or buses to the selected bus back to factory defaults.
CLR + Mute Master 1-8
While in MUTE setup mode: Clear channel mute assignments to the selected Mute Master.
CLR + VCA Master 1-8
While in VCA setup mode: Clear Fader assignments to the selected VCA Master.
ALT + CLR Functions
ALT + CLR + SEL
Reset all audio parameters in all like-for-like channels across the whole console (does not affect functions such as
SOLO, bus type, names patching and mute assignment, or preamp gain).
ALT + CLR + EQ
Clear all EQ section parameters across the whole console (on ALL channels).
ALT + CLR + HPF
Reset all High Pass Filters across the whole console to default.
ALT + CLR + COMP
Clear all Compressor section parameters across the whole console.
ALT + CLR + GATE
Clear all GATE section parameters across the whole console.
ALT + CLR + PHASE
Resets the phase to Off across the whole console.
ALT + CLR + LR
Resets all LR routing to Off across the whole console.
ALT + CLR + MONO
Resets all MONO routing to Off across the whole console.
To Next Page
Loading...
