Re-Tighten the
2 bolts and nuts.
Re-Tighten the
2 bolts and nuts.
Replace
Shaft Collar
Higheror lower arm
settingscan be achieved
by removingtop shaft
collar, retracting
T-handle, and re-inserting
arm from aboveor below.
Replace
Shaft Collar
Higheror lower arm
settingscan be achieved
by removingtop shaft
collar, retracting
T-handle, and re-inserting
arm from aboveor below.
34
Section 2 : inStaller
Lift Adjustments
AL560 & AL580 SERIES
HOLDDOWN ARM ADJUSTMENT
1. Drive chair onto platform after cradles have been adjusted.
(See prior page.) [Figure 34-1]
2. Raise platform to top of travel until you hear the clutch.
[Figure 34-2]
3. Loosen the two bolts and nuts in back of the vertical tube.
[Figure 34-3 and 34-4] Allow arm assembly to lower until the
arm contacts the seat.
4. Lower the platform approximately 2” to 3.” Allow arm to
drop with seat. Re-tighten the two bolts and nuts. [Figure 34-5]
5 Run lift up until top of travel, when you hear the clutch.
CAUTION!
Verify that the hold-down arm produces
enough pressure on the seat to hold the
power chair firmly to the platform. The
seat should be somewhat indented by
the arm. [Figure 34-7]
NOTE: Higher or lower arm settings can be
achieved by removing top shaft collar, retracting
T-handle, and re-inserting arm from above or
below. [Figure 34-6]
This method allows the T-handle to remain on the
same side as the key and toggle switches
OR
Entire assembly can be flipped IF desired for
opposite T-handle location.
Figure 34-1
Figure 34-2
Figure 34-3
Figure 34-4
Figure 34-5 Figure 34-6 Figure 34-7
To Next Page
Loading...
