How to stop a Harmar Mobility AL600 lift from rattling while driving?
Ensure that you press the ‘IN’ button until the platform is fully engaged in its locking mechanism. Also, check the rear limit switch to be sure the lift is backing all the way into the vehicle.
What to do if my scooter/chair tips while using Harmar Mobility AL600?
If your scooter or chair tips forward or backward while being lifted by a Harmar Mobility Lifting System, it's likely that the button was held too long, unwinding the lifting strap. To fix this, press whichever button extends the strap and continue to hold it until the strap returns to the proper direction.
Why is my Harmar Mobility AL600 Lifting Systems lifting tower operating in reverse?
If your Harmar Mobility Lifting Tower operates in reverse, adjust the position of the chair or scooter on the platform. In some cases, a scooter plate can be added to the platform to allow more offset, because the platform is leaning to one side more than the other.
Why does my Harmar Mobility AL600 lift operate slowly or intermittently?
The most common reason for a Harmar Mobility Lifting System to operate poorly is a bad electrical connection. Check and clean all connections that may be loose or dirty, as the lifting motor requires quality electrical connections to operate at full capacity. Any break in the wiring will slow down the motor and cause it to deteriorate prematurely. Also, inspect the full length of the wire harness for tears in the insulation, especially the vehicle power harness running through or under the vehicle. Road debris and rubbing against the vehicle’s frame can cause a short. Verify the circuit breaker, located about 6” from the connections to the vehicle’s battery, is functioning correctly. The breaker will self-reset if overloaded; however, verify (with an Ohm meter or test light) that the break...
Detailed steps for loading and securing mobility devices onto the lift platform.
Essential safety warnings, cautions, and maintenance procedures for the lift.
Recommendations for preventative maintenance to ensure long-term lift reliability.
Lists the essential tools needed for the successful installation of the lift.
Instructions for unpacking the lift and verifying all components are present.
Detailed guide for connecting the lift's wiring harness to the vehicle's electrical system.
Guidance for diagnosing and resolving common lift issues.
Solutions for lift operation issues, focusing on electrical connections and breakers.
Detailed wiring diagram illustrating component connections for AL600/AL690.
General| Brand | Harmar Mobility |
|---|---|
| Model | AL600 |
| Category | Lifting Systems |
| Language | English |
To Next Page
