Harmar Mobility AL600 - SECTION 2: INSTALLER; Installation Preparation; Tools Required for Installation

| www.harmar.com | 800-833-0478
TEC0020 2018JAN3 P/N: 630-00025 Rev D AL600 & AL690 Hybrid Installation & Owner's Manual
8
SECTION 2 : INSTALLER
Preparation
SOCKET SET
Specically
WRENCH SET
Specically
7/16”
3/4”
3/8"
ALLENWRENCH SET
Specically
1/8”
3/16”
5/16”
#2 FLATHEAD
SCREWDRIVER
#2 PHILLIPSHEAD
SCREWDRIVER
WIRE
CUTTERS
NEEDLE NOSE
PLIERS
MARKING
IMPLEMENT
TAPE MEASURE
9/16”
7/16”
3/4”
9/16”
TOOLS REQUIRED
Installations may vary to some degree, but below are the basic tools to have
on hand for an Hybrid Lift installation.