1. Insert ‘T-Shape’ plasc extensions on base of backrest
into the corresponding slots on seat base ❶.
2. Push unl both insert ❷.
3. While holding fabric down at rear of seat base, slowly
swing the backrest upwards, whereby locking the
backrest into place ❸. The hook-and-loop poron
of the fabric at rear of seat should be the
backrest ❹.
3. Secure fabric ❺.
4. To remove backrest, repeat previous steps in reverse
order.
❶
❸
❹
❺
❷
In very few vehicles, the booster seat cannot be
properly installed because of the type of seat, seat
16
To Next Page