2
D-G 16 S2 - 18.04.13 / Vers.: 1
1 Safety
1.1 Correct use
The D-G 16 S2 automatic blasting unit is used in dental laboratories
-
to remove embedded material residue and oxides on cast parts after implanting,
-
for levelling and smoothing cast part surfaces and,
-
for polishing.
Unauthorized modifications and additions are not permitted for safety reasons!
The operating and maintenance conditions specified in these operating instructions must be ad-
hered to.
Caution
The unit is not designed as a medical device!
Use on people is prohibited!
1.2 Possible dangers
-
The sandblasting unit D-G 16 S2 is safe if used properly, but with improper and negligent use
there is a risk of injury from the sandblast emanating from the injector (eye or skin injuries).
-
Before maintenance and cleaning work, the device must be switched off at the main power
switch and the mains connector must be disconnected (pull out the power plug).
-
Before every access to the internal electrical components, the device must be disconnected
from the mains.!
-
If the front lid is open or loose the injector may not be switched on.
-
No cinders may be sucked into the built-in aspirator.
Danger
The unit is not suitable for use in rooms where special conditions exist (e.g. corrosive or poten-
tially explosive atmospheres).
1.3 Approved operators
The operator of the unit should ensure that the operating instructions are accessible to the op-
erating personnel and have been read and fully understood. Only then should the operator
commission the unit.
1.4 Safety measures at site of operation
-
The installation surface must be stable and level enough to support the weight of the automatic
blasting unit.
-
Ensure that no foreign bodies enter the ventilation apertures of the unit.
-
Ensure that the workplace complies with accident prevention regulations at all times through the
enforcement of suitable directions and inspection measures.
To Next Page
Loading...