To Next PageTo Next Page
Need help?Do you have a question about the Harnisch+Rieth D-G 16 S2 and is the answer not in the manual?
Defines the intended use of the automatic blasting unit in dental laboratories.
Highlights risks like eye/skin injuries from sandblast and electrical hazards.
Emphasizes that operators must read and understand instructions before use.
Outlines stable installation and workplace safety compliance requirements.
Explains the meaning of "Note", "Caution", and "Danger" symbols.
Lists key specifications like dimensions, power, pressure, and weight.
Details steps for removing the unit from its crate and checking accessories.
Describes the unit's dual functionality and identifies components via illustration.
Outlines the sequence of steps to prepare the unit for operation.
Instructs on connecting the unit to the compressed air supply, emphasizing clean air.
Details the types of blasting agents and the procedure for filling the unit.
Explains how to correctly install and check the filter bag and super-fine filter.
Describes how to set up and start the automatic blasting process using the control panel.
Explains the procedure for setting, adjusting, and saving the blasting duration.
Guides users on operating the unit in manual mode using the foot switch.
Explains the function of the automatic cut-out and the filter change indicator light.
Provides step-by-step instructions for safely replacing the filter bag.
Details the procedure for cleaning or replacing the super-fine filter.
Explains how to clean the sieve to remove embedded material.
Describes the process for draining the abrasive material from the unit.
Outlines checks for the injector, jet nozzle, and aspirator basket when performance degrades.
Recommends regular checks for abrasive-exposed components to prevent wear.
General| Type | Angle Grinder |
|---|---|
| Power | 1600 W |
| No-load speed | 8500 rpm |
| Spindle thread | M14 |
| Protection class | Class II |
