Harris BMXDIGITAL 99-1200-0 - Remote Line Selector (RLS) Module Guide

Revision C • 1/04
HARRIS CORPORATION
2-28
2 Installation
di
g
ital
QUICK GUIDE TO THE REMOTE LINE SELECTOR (RLS) MODULE
Three connectors come standard on the optional Remote Line Selector (RLS) module: one 6-pin
analog audio input connector, one 3-pin digital audio input connector, and one 24-pin logic connector.
The connectors are hidden by the meter panel in normal operation.
AUDIO INPUTS
ANALANAL
ANALANAL
ANAL
OG INPUT —OG INPUT —
OG INPUT —OG INPUT —
OG INPUT — The 6-pin analog input accepts stereo signals or
mono signals. When a mono input is used, parallel the signal to the left
and right inputs.
DIGITDIGIT
DIGITDIGIT
DIGIT
AL INPUT —AL INPUT —
AL INPUT —AL INPUT —
AL INPUT — The 3-pin digital input accepts AES-3
(AES/EBU) or S/PDIF signals (when the circuit shown on page 2-11 is used).
LOGIC
LL
LL
L
OGIC I/O —OGIC I/O —
OGIC I/O —OGIC I/O —
OGIC I/O — The 24-pin logic connector controls the device connected
to the module. Devices typically connect through a switcher (an External
RLS under module control or a router), although a device can connect
directly to the module as well. The source type and switcher type are
configured via the module’s SETUP DIP switches (settings listed on page 2-
29). Logic connections vary depending on the type of device connection.
For more information, see pages 2-30 and 2-31.
Analog Inputs - Stereo
Right High (+)
Right Low (-)
Shield
Left High (+)
Left Low (-)
Shield
3
2
1
6
5
4
(wire insertion end view)
Analog Inputs - Mono
High (+)
Low (-)
Shield
High (+)
Low (-)
Shield
3
2
1
6
5
4
(wire insertion end view)
Digital Inputs
High (+)
Low (-)
Shield
3
2
1
(wire insertion end view)