Harris BMXDIGITAL 99-1200-0 - Studio Module Guide

Revision C • 1/04
HARRIS CORPORATION
2-40
2 Installation
di
g
ital
QUICK GUIDE TO THE STUDIO MODULE
Twelve connectors come standard on the Studio module: eight 6-pin analog audio output connectors
(four for each studio), two 14-pin main logic connectors (one for each studio), and two 16-pin logic
connectors (one for a Producer’s talkback and one for an External location talkback). The connectors
are hidden by the meter panel in normal operation.
AUDIO OUTPUTS
MONITMONIT
MONITMONIT
MONIT
OR —OR —
OR —OR —
OR — The 6-pin analog outputs for the monitor speaker
amplifiers in Studio 1 and Studio 2. The outputs are wired using the standard
pinout sequence.
HOSTHOST
HOSTHOST
HOST
,,
,,
,
C C
C C
C
O-HOSTO-HOST
O-HOSTO-HOST
O-HOST
,,
,,
,
GUEST — GUEST —
GUEST — GUEST —
GUEST — The 6-pin analog outputs for the
headphone amplifiers for a host, co-host, and the guests in Studio 1 and
Studio 2. The outputs are wired using the standard pinout sequence.
LOGIC I/O
LL
LL
L
OGIC 1,OGIC 1,
OGIC 1,OGIC 1,
OGIC 1,
L L
L L
L
OGIC 2 —OGIC 2 —
OGIC 2 —OGIC 2 —
OGIC 2 — The two 14-pin Main logic connectors have
dimming, muting, and warning light commands for the two studios. For
more information, see pages 2-42 and 2-43.
PRPR
PRPR
PR
ODUCER —ODUCER —
ODUCER —ODUCER —
ODUCER — The 16-pin Producer connector has the producer’s
talkback audio and logic inputs and Tally outputs. For additional
information, see pages 2-44 and 2-45.
EXEX
EXEX
EX
TERNAL —TERNAL —
TERNAL —TERNAL —
TERNAL — The 16-pin External connector has the external location’s
talkback audio and logic inputs and Tally outputs. For additional
information, see pages 2-46 to 2-49.
Analog Outputs
Right High (+)
Right Low (-)
Shield
Left High (+)
Left Low (-)
Shield
3
2
1
6
5
4
(wire insertion end view)