Harris BMXDIGITAL 99-1200-0 - Page 53

2 Installation
di
g
ital
Revision C • 1/04
HARRIS CORPORATION
2-41
SETUP
SETUP —SETUP —
SETUP —SETUP —
SETUP — These eight DIP switches set logic functionality for Studio outputs per the Studio Module
Switch Definitions table below.
MIC TRIM
CC
CC
C
ONSOLEONSOLE
ONSOLEONSOLE
ONSOLE
,,
,,
,
PR PR
PR PR
PR
ODUCER,ODUCER,
ODUCER,ODUCER,
ODUCER,
EX EX
EX EX
EX
TERNAL —TERNAL —
TERNAL —TERNAL —
TERNAL — These three trimpots set the talkback levels for the
console mic, the producer’s mic, and the external location’s mic.
Studio Module Switch Definitions
# Switch Name ON Function (set to operator’s left) OFF Function (set to operator's right)
1 Studio 1: Auto-switch Automatic switching from External No automatic monitor source switching
External Inputs 1 & 2
1
Input 1 to Input 2 while there is a hot mic with a hot mic in Studio 1
in Studio 1
2 Studio 1: Auto-switch Automatic switching from External No automatic monitor source switching
External Inputs 3 & 4
2
Input 3 to Input 4 while there is a hot mic with a hot mic in Studio 1
in Studio 1
3 Studio 2: Auto-switch Automatic switching from External No automatic monitor source switching
External Inputs 1 & 2
1
Input 1 to Input 2 while there is a hot mic with a hot mic in Studio 2
in Studio 2
4 Studio 2: Auto-switch Automatic switching from External No automatic monitor source switching
External Inputs 3 & 4
2
Input 3 to Input 4 while there is a hot mic with a hot mic in Studio 2
in Studio 1
5 Studio 1: Co-host Allows co-host in Studio 1 to receive Selector audio is enabled
receives talkback talkback only and disables selector
only audio
6 Studio 2: Co-host Allows co-host in Studio 2 to receive Selector audio is enabled
receives talkback talkback only and disables selector
only audio
7 External mute/dim Pins 4 and 5 are logic outputs: pin 4 Pins 4 and 5 are logic inputs: pin 4 is Talk to
output enable is an External Mute Command and Studio 1 (-) and pin 5 is Talk to Studio 1
pin 5 is External Dim Command. Host (-)
8 Spare Switch
STUDIO MODULE SWITCHES AND MIC TRIMS
1
When set to ON, the monitor source automatically switches between External Input 1 (which typically has the
off-air monitor, with delay) and External Input 2 (which has a synthetic air signal with little or no delay). When
External 1 is selected as the monitor source, and a Control Room mic module is turned on, the monitor source
automatically changes to External Input 2. When all Control Room mic modules are off, then External Input 1 is
automatically selected.
2
When set to ON, the monitor source automatically switches between External Input 3 (which would be the off-air
monitor, with delay), and External Input 4 (which has a synthetic air signal with little or no delay). When External 3
is selected as the monitor source, and a Control Room mic module is turned on, the monitor source automatically
changes to External Input 4. When all Control Room mic modules are off, then External Input 3 is automatically
selected.