Harris Maxiva ULX COFDM Series - Page 219

10/6/10 888-2629-200 5-31
WARNING: Disconnect primary power prior to servicing.
Section 5 Maintenance and Alignments
Maxiva ULX COFDM Series
L
Figure 5-19 Reject Load Elbow.
STEP 11 Remove the sample cables from the directional coupler at the output
of the hybrid combiner.
STEP 12 While supporting the weight of the hybrid combiner/coax RF system
loosen the clamps on outer conductor sleeves at the output of the
lower and then the upper module combiners. Slide the coaxial
sleeves to the right to expos the inner conductor. The loosened upper
clamp is show in
Figure 5-20 on page 5-32.
Clamp
Elbow
Reject
Load