Revision A • 6/06
HARRIS CORPORATION
3-7
3 Using NetWave
MONITOR PANEL, CENTER COLUMN CONTROL DETAIL
CONTROL ROOM MONITOR SOURCE
All control room outputs use the same selected monitor source. The selected source is indicated by
the lit button. Only one button can be selected at a time.
PGM 1-4 — PGM 1-4 —
PGM 1-4 — PGM 1-4 —
PGM 1-4 — When lit, routes the selected Program bus to the control room outputs.
EXEX
EXEX
EX
T 1,T 1,
T 1,T 1,
T 1,
EX EX
EX EX
EX
T 2 — T 2 —
T 2 — T 2 —
T 2 — When lit, routes the selected External signal to the control room outputs.
DISPLAYS
VV
VV
V
istaMistaM
istaMistaM
istaM
ax Eax E
ax Eax E
ax E
nabled — nabled —
nabled — nabled —
nabled — When lit, indicates the console is ready to be networked with a VistaMax
audio management system. If it is not lit, the console is a stand-alone console without networking
capability.
CC
CC
C
onon
onon
on
trtr
trtr
tr
ol Rol R
ol Rol R
ol R
oo
oo
o
om Mom M
om Mom M
om M
utut
utut
ut
e — e —
e — e —
e — When lit, indicates the room monitor output and control room
warning logic are active due to one or more channels, that have a control room mic as their
input, are on and assigned to a program bus. When unlit, no channel that has a control room
mic as its source is turned on.
FADERS
RR
RR
R
oo
oo
o
om Mom M
om Mom M
om M
onitonit
onitonit
onit
or — or —
or — or —
or — 100mm fader for adjusting the volume of the control room monitor output.
It affects the level of the control room (CR MON) output.
HH
HH
H
eadphones — eadphones —
eadphones — eadphones —
eadphones — 100mm fader for adjusting the output volume of the board operator
headphone jack (1/4" TRS) in the console’s left side panel.
.
To Next Page
Loading...
Need help?
General
